Home › Engine / Hybrid System › B58 (COOLING) › RESERVOIR TANK (for High Temperature)
RM3650E _51 Engine / Hybrid System _080128 B58 COOLING _0388823 RESERVOIR TANK(for High Temperature) A

B58 COOLING  RESERVOIR TANK(for High Temperature)  REMOVAL  


PROCEDURE

Hide 51219 1.REMOVE FRONT SUSPENSION MEMBER LOWER PROTECTOR

Hide 16470 2.REMOVE RADIATOR RESERVE TANK ASSEMBLY

CAUTION:
·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.




NOTICE:
·

Life-long fill of coolant!

·

Do not reuse used coolant.

When replacing and removing components which rely on the corrosion protection effect of the coolant, it is essential to change the coolant. The cooling system must therefore be emptied and refilled.

In the case of other removal work involving the draining of part quantities of coolant, the coolant level must be topped up with new coolant.

·

Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.



a.
A433991

Disconnect the coolant lines with the special tool.

SST
09900-WA090  


b.
A442299

Loosen reserve tank cap sub-assembly (1).


c.

Draw off the coolant with a conventional pump.


d.
A442295

Disconnect the radiator reserve tank hose (1) with the disconnection tool.


e.

Disengage the clamp (2) to disconnect the No. 5 water by-pass hose (4) from the radiator reserve tank assembly (3).


f.

Unlock and disconnect the radiator reserve tank hose (1).


g.

Catch and dispose of escaping coolant.


h.
A442296

Disconnect the heater water hose (1) with the disconnection tool.


i.

Unlock and disconnect the heater water hose (1).


j.

Catch and dispose of escaping coolant.


k.

Disengage the clamp (4) to disconnect the wire harness from the radiator reserve tank assembly (3).


l.

Disconnect the connector (2) from the radiator reserve tank assembly (3).


m.
A442297

Unlock the lock (1).


n.

Pull the journal (2) of the radiator reserve tank sub-assembly (3) out of the rubber mount.


o.

Remove the radiator reserve tank sub-assembly (3) and set it aside.


p.
A442298

Unlock the lock (1) and remove the radiator reserve tank assembly (2).