Home › Engine / Hybrid System › B58 (COOLING) › RESERVOIR TANK (for Low Temperature)
RM3650E _51 Engine / Hybrid System _080128 B58 COOLING _0388824 RESERVOIR TANK(for Low Temperature) A

B58 COOLING  RESERVOIR TANK(for Low Temperature)  REMOVAL  


PROCEDURE

Hide 51219 1.REMOVE FRONT SUSPENSION MEMBER LOWER PROTECTOR

Hide 16482 2.REMOVE LOW TEMPERATURE RADIATOR RESERVE TANK SUB-ASSEMBLY

CAUTION:
·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.




NOTICE:
·

Life-long fill of coolant!

·

Do not reuse used coolant.

When replacing and removing components which rely on the corrosion protection effect of the coolant, it is essential to change the coolant. The cooling system must therefore be emptied and refilled.

In the case of other removal work involving the draining of part quantities of coolant, the coolant level must be topped up with new coolant.

·

Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.



a.
A433991

Disconnect the coolant lines with the special tool.

SST
09900-WA090  


b.
A442300

Loosen radiator reserve tank cap sub-assembly (1).


c.

Draw off the coolant with a conventional pump.


d.
A442301

Disconnect the No. 5 water by-pass hose (1) with the disconnection tool.


e.

Unlock and disconnect the No. 5 water by-pass hose (1).


f.

Catch and dispose of escaping coolant.


g.

Disconnect the connector (2) from the radiator reserve tank assembly (3).


h.
A442297

Unlock the lock (1).


i.

Detach the journal (2) of the radiator reserve tank sub-assembly (3) from the rubber mount.


j.
A442303

Pull the radiator reserve tank sub-assembly (1) up until the No. 6 water by-pass hose (2) is accessible.


k.

Disconnect the No. 6 water by-pass hose (2) with the disconnection tool.


l.

Unlock and disconnect the No. 6 water by-pass hose (2).


m.

Catch and dispose of escaping coolant.


n.

Guide out and remove the radiator reserve tank sub-assembly (1).