When the engine is stopped after the end of the journey, it may be necessary to run the electric fan. In rare cases, operation of the electric fan can last up to 11 min. This protects the components. In this case, replacing the electric fan will not remedy the problem!
81150
1.REMOVE HEADLIGHT ASSEMBLY LH
81110
2.REMOVE HEADLIGHT ASSEMBLY RH
Use the same procedure as for the LH side.
53111M
3.REMOVE FRONT BUMPER INNER SUPPORT
52521B
4.REMOVE FRONT BUMPER UPPER RETAINER
53295A
5.REMOVE RADIATOR UPPER AIR DEFLECTOR
53205
6.REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY
Loosen the clips (1).
Place wiring harness (2) to one side.
Unclip the housing (1) in the marked areas.
Detach the Bowden cables (2) at the separation point in the housing (1) where required.
Loosen bolts (1).
Loosen E14 bolts (2).
Unscrew the bolts (3) and remove the upper radiator support sub-assembly.
16360A
7.REMOVE FAN WITH MOTOR ASSEMBLY
Hot surfaces.
Risk of burning!
Perform all work only on components that have cooled down.
Release the automatic transmission oil cooler tube (1) from the holder (2) on the fan with motor assembly.
Unlock plug connection (1) and disconnect
Loosen T30 screw (2).
Unlock the right lock (3).
Remove fan with motor assembly (1) in direction of arrow.