Home › General › MAINTENANCE › B48 DRIVE BELT
RM3650E _V1 General _079881 MAINTENANCE _0388856 B48 DRIVE BELT A

MAINTENANCE  B48 DRIVE BELT  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FAN AND GENERATOR V BELT

CAUTION:
·

Component with preload.

Danger of injury!

-

Reduce preload as far as possible before disassembly. Relieve component.




a.
A441806

Feed in the fan and generator V belt (1) and install it.


b.
A445282C02
2.042,1.833 2.5,1.583 true 2.49,1.469 2.802,1.625 0.313,0.156 10 true *a
*a 4 mm Hexagon Wrench


Using 16 mm socket, raise the preloading on the belt tensioner (1) in the direction of arrow.


c.

Remove the 4 mm hexagon wrench from belt tensioner (1).


Hide 16109 2.INSTALL WATER PUMP SUB-ASSEMBLY

a.
A442309

Feed in and install the water pump sub-assembly (3).


b.

Tighten the nut (2) on the holder.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


c.

Connect and lock the connector (1).


d.

Make sure the connector (1) engages audibly.


Hide 11401T 3.INSTALL CYLINDER BLOCK COVER

a.
A441753

Thread in and position the cylinder block cover (2).


b.

Fit all expanding rivets in marked areas.


c.

Secure clamps (1).


Hide 12601B 5.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY