Home › Engine / Hybrid System › B48 (ENGINE MECHANICAL) › CAMSHAFT (for No. 3)
RM3650E _51 Engine / Hybrid System _080178 B48 ENGINE MECHANICAL _0388870 CAMSHAFT(for No. 3) A

B48 ENGINE MECHANICAL  CAMSHAFT(for No. 3)  INSTALLATION  


PROCEDURE

Hide 13053 1.INSTALL NO. 3 CAMSHAFT SUB-ASSEMBLY

a.
A441667

Check ring pins (1) for damage and replace if necessary.


b.
A441666

Check all needle bearings (1) for ease of movement.

i.

Replace the No. 3 camshaft sub-assembly in case of tight needle bearings (1).



c.

Coat needle bearing (1) with new engine oil.


d.
A441668

Clean bearing positions (1) and coat with new engine oil.


e.
A441277

Push needle bearing (1) up to the limit position in direction of arrow before installing the No. 3 camshaft sub-assembly.


f.
A441669

Insert No. 3 camshaft sub-assembly (1) in the cylinder head.


g.

Install bearing cap (2) and (3) on the cylinder head sub-assembly.

HINT:

All bearing caps must be installed again in the same position from where they were removed.



h.
A441633

Make sure the bearing cap (1) is installed correctly.

i.

The bearing cap (1) is provided with a limit position.



i.
A441664

Tighten down T30 bolts (1) and (2) uniformly.

Torque:
8.6 N*m (88 kgf*cm, 76 in.*lbf)


Hide 13501A 2.INSTALL INTAKE CAMSHAFT SUB-ASSEMBLY