1.INSTALL VALVE STEM OIL SEAL
The description is for one component only. The procedure is identical for all further components.
Remove oil and dirt from the contact surface (1).
Replace the valve stem oil seal (1).
Make sure that the special tool 0 490 797 (11 1 960) is used when installing the valve stem oilseal.
Guide in and install the special tool 0 490 797 (11 1 960) on valve (1).
Guide in and install valve stem seal (1) on the special tool 0 490 797 (11 1 960).
Guide the special tool 0 490 797 (11 1 960) outand remove.
Press the valve stem oil seal (1) onto the cylinder head sub-assembly till the limitposition using special tool 0 493 249 (11 6 380).
2.INSTALL COMPRESSION SPRING