1.INSTALL EXHAUST VALVE COMPRESSION SPRING
Spring preload.
Danger of injury!
The use of the specified special tool (tool) is mandatory.
The described operation must be carried out properly.
The description is for one component only. The procedure is identical for all further components.
Note the installation position of the exhaust valve compression spring.
Install the exhaust valve compression spring that the larger diameter (Y) points to the lower spring cup.
Make sure that the intake valve compression springs are not switched with the exhaust valve compression springs.
The exhaust valve compression springs (1) have been color-coded (2).
Color of the exhaust valve compression springs: green/yellow
Install the exhaust valve compression spring (2) and the exhaust evalve spring retainer (1).
Using SST, compress each exhaust valve compression spring and install the 8 valve spring retainer locks.
Wear safety goggles.
2.INSTALL INTAKE VALVE COMPRESSION SPRING
Spring preload.
Danger of injury!
The use of the specified special tool (tool) is mandatory.
The described operation must be carried out properly.
The description is for one component only. The procedure is identical for all further components.
Note the installation position of the intake valve compression spring.
Install the intake valve compression spring such that the larger diameter (Y) points to the lower spring cup.
Make sure that the intake valve compression springs are not switched with the exhaust valve compression springs.
The intake valve compression springs (1) have been color-coded (2).
Color of the intake valve compression springs: green
Install the intake valve compression spring (2) and the intake valve spring retainer (1).
Using SST, compress each intake compression spring and install the 8 valve spring retainer locks.
Wear safety goggles.
13750
3.INSTALL VALVE LASH ADJUSTER ASSEMBLY
13801
4.INSTALL NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY
13502B
5.INSTALL EXHAUST CAMSHAFT SUB-ASSEMBLY
13053
6.INSTALL NO.3 CAMSHAFT SUB-ASSEMBLY
13501A
7.INSTALL INTAKE CAMSHAFT SUB-ASSEMBLY
13800
8.INSPECT INTERMEDIATE LEVER
13800
9.INSTALL INTERMEDIATE LEVER
13908A
10.INSTALL GATE
11.INSTALL TORSION SPRING
17201
12.INSTALL TURBOCHARGER SUB-ASSEMBLY
11115
13.INSTALL CYLINDER HEAD GASKET