Home › Engine / Hybrid System › B48 (ENGINE MECHANICAL) › REAR CRANKSHAFT OIL SEAL
RM3650E _51 Engine / Hybrid System _080178 B48 ENGINE MECHANICAL _0388845 REAR CRANKSHAFT OIL SEAL A

B48 ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 2.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

NOTICE:
·

Heavy components can lead to injury or damage.

-

Remove and install heavy components with the aid of another person/other persons.




a.
A441285

Position special tool 0 496 595 (11 6 130) and fasten with bolt (1).

SST
09700-WA040  


b.

Slide counter support on the bolt (2) in direction of drive plate and ring gear sub-assembly and turn the engine on the crankshaft pulley assembly until the gearing (3) engages in the drive plate and ring gear sub-assembly.


c.

Tighten the bolt (2).


d.
A444853

Loosen bolts (1) to (8).


e.

Remove special tool 0 493 938 (11 9 260).

SST
09200-WA200  


Hide 3.REMOVE TIMING CHAIN COVER OIL SEAL

a.
A441644

Remove the No. 1 crank angle sensor plate (1).


b.

Protect the No. 1 crank angle sensor plate from swarf with a plastic bag.

i.

The No. 1 crank angle sensor plate is magnetic.



c.
A441203

Drill a hole at the timing chain cover oil seal (arrow).

i.

For this purpose, use a drill (1) with a maximum diameter of 2.5 mm.



d.

Remove the swarf immediately with the vacuum cleaner.

i.

The swarf must not be removed with compressed air.



e.
A441204

Bolt in special tool 0 491 454 (23 0 490) in direction of arrow.

SST
09200-WA140  


f.

Drive out timing chain cover oil seal with the impact weight in direction of arrow.


g.

Replace the timing chain cover oil seal.