Home › Engine / Hybrid System › B58 (ENGINE MECHANICAL) › CAMSHAFT (for No. 3)
RM3650E _51 Engine / Hybrid System _080179 B58 ENGINE MECHANICAL _0388908 CAMSHAFT(for No. 3) A

B58 ENGINE MECHANICAL  CAMSHAFT(for No. 3)  INSTALLATION  


PROCEDURE

Hide 13053 1.INSTALL NO. 3 CAMSHAFT SUB-ASSEMBLY

a.
A441323

Check all the needle bearings (arrows) of the No. 3 camshaft sub-assembly for ease of movement.


b.

Replace the No. 3 camshaft sub-assembly in case of tight needle bearings.


c.
A441324

Clean all the bearing positions (arrows) in the cylinder head sub-assembly and coat them with engine oil.


d.
A441325

Check all ring pins (marks) (1) for damage and replace them if necessary.


e.
A441277

Push needle bearing (1) up to the limit position in direction of arrow before installing the No. 3 camshaft sub-assembly.


f.

Oil all needle bearings of the No. 3 camshaft sub-assembly (1).


g.
A441322

Install No. 3 camshaft sub-assembly (1) in the cylinder head sub-assembly.


h.
A441321

Install the bearing caps.

HINT:

All the bearing caps must be installed again in the position from where the bearing caps were removed.



i.

Tighten the T30 bolts (1).

Torque:
9.6 N*m (98 kgf*cm, 85 in.*lbf)


j.
A441320

Install bearing cap (1) provided with a limit position.


k.

Tighten the T30 bolts (1).

Torque:
9.6 N*m (98 kgf*cm, 85 in.*lbf)


Hide 13501A 2.INSTALL INTAKE CAMSHAFT SUB-ASSEMBLY