Home › Engine / Hybrid System › B58 (ENGINE MECHANICAL) › OIL PUMP DRIVE CHAIN
RM3650E _51 Engine / Hybrid System _080179 B58 ENGINE MECHANICAL _0388910 OIL PUMP DRIVE CHAIN A

B58 ENGINE MECHANICAL  OIL PUMP DRIVE CHAIN  INSTALLATION  


PROCEDURE

Hide 13507A 1.INSTALL OIL PUMP DRIVE CHAIN SUB-ASSEMBLY

a.
A442091

Guide in and install oil pump drive chain sub-assembly (1) on crankshaft (2).


b.
A442090

Position oil pump drive shaft sprocket (2) on the oil pump assembly so that the labelling on the oil pump drive shaft sprocket (2) is facing away from the oil pump assembly.

HINT:

The thread is a left-hand thread.



c.

Insert the oil pump drive shaft sprocket (2) in the oil pump drive chain sub-assembly.


d.

Replace the bolt (1).


e.

Hold the oil pump drive shaft sprocket (2), tighten the T45 bolt (1).

SST
09960-10010  (09962-01000, 09963-00700)

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


f.

Using SST, tighten the T45 bolt (1) an additional 90°.

SST
09900-WA010  

HINT:
C417459C05
2.99,1.271 3.156,1.188 false 2.906,2.094 2.906,1.76 false 0.875,3 1.208,3 false 0.104,0.125 0.417,0.281 0.313,0.156 10 false *a 0.448,0.125 0.76,0.281 0.313,0.156 10 false *b 2.042,0.125 2.354,0.281 0.313,0.156 10 false *c 3.188,1.073 3.427,1.271 0.24,0.198 10 false *d 2.854,2.146 3.167,2.302 0.313,0.156 10 false *b 1.302,2.927 1.615,3.083 0.313,0.156 10 false *c
*a Example
*b Before Tightening
*c After Tightening
*d Magnetic Portion


·

The magnetic portion is used to secure the gauge to the vehicle.

·

After first adjusting the needle of the gauge to 0°, tighten to the specified angle.

·

Perform the work procedure carefully so that the gauge, etc. does not become tilted.