Home › Steering › STEERING COLUMN › STEERING WHEEL
RM3650E _55 Steering _080257 STEERING COLUMN _0389218 STEERING WHEEL A

STEERING COLUMN  STEERING WHEEL  INSTALLATION  


PROCEDURE

Hide 1.INSTALL STEERING WHEEL WIRING HARNESS

a.

Insert the steering wheel wiring harness.


Hide 45123 2.INSTALL STEERING WHEEL MOTOR

a.

Install steering wheel motor.


b.

Tighten down T20 screw.

Torque:
4.0 N*m (41 kgf*cm, 35 in.*lbf)


c.

Connect connectors and lock.


d.

Position cable.


e.

Tighten down T20 screw.

Torque:
4.0 N*m (41 kgf*cm, 35 in.*lbf)


Hide 3.INSTALL STEERING WHEEL HEATER CONTROL ASSEMBLY

a.
C413521

Position the steering wheel heater control assembly (2).


b.

Connect and lock both connectors (1).


Hide 45116 4.INSTALL NO. 1 STEERING WHEEL ORNAMENT

a.
C413519

Carefully clip the No. 1 steering wheel ornament (1) into the latch mechanisms (2).


Hide 84250A 5.INSTALL STEERING PAD SWITCH ASSEMBLY

Hide 84610F 6.INSTALL TRANSMISSION SHIFT SWITCH ASSEMBLY

Hide 84306 7.INSPECT SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

a.
C420092C01
2.458,1.865 2.458,1.531 true 2.479,4.25 2.479,3.917 true 2.771,0.771 2.51,1.292 true 0.219,0.177 0.531,0.333 0.313,0.156 10 false *a 0.24,2.563 0.552,2.719 0.313,0.156 10 false *b 2.385,1.906 2.844,2.104 0.458,0.198 10 false (2) 2.406,4.281 2.865,4.479 0.458,0.198 10 false (2) 2.792,0.573 3.25,0.771 0.458,0.198 10 true (1)
*a Correct
*b Incorrect


Check the neutral position of the spiral cable:

i.

Check the correct mark (1) in the inspection glass (2).

NOTICE:

If the no correct mark (1) is visible, turn the spiral cable until the right mark (1) becomes visible.




Hide 45100 8.INSTALL STEERING WHEEL ASSEMBLY

a.
C413499

A micro-encapsulated screw (3) may be fitted.


b.

Check the screw connection.


c.

Screw (3) is micro-encapsulated.


d.

Clean thread in the steering column assembly.


e.

Replace the screw (3).


f.
C413498

Align and connect the steering wheel assembly according to the mark (1) with the steering column mark (2).


g.
C413499

Connect connectors (1) and (2) and lock.


h.

Tighten down 16 mm bolt (3).

Torque:
62.5 N*m (637 kgf*cm, 46 ft.*lbf)


Hide 45130 9.INSTALL HORN BUTTON ASSEMBLY