Home › Steering › STEERING COLUMN › STEERING COLUMN HOLE COVER
RM3650E _55 Steering _080257 STEERING COLUMN _0389220 STEERING COLUMN HOLE COVER A

STEERING COLUMN  STEERING COLUMN HOLE COVER  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

Damage to spiral cable sub-assembly.

The spiral cable sub-assembly can be damaged by twisting the steering wheel if the universal joint is disconnected from the steering gear or the steering shaft below or when the steering shaft is disconnected from the steering column below.

-

Secure steering wheel from twisting.




HINT:
·

Use the same procedure for LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.



PROCEDURE

Hide 51219 1.REMOVE FRONT SUSPENSION MEMBER LOWER PROTECTOR (for LHD)

Hide 12611 2.REMOVE NO. 1 ENGINE COVER (for RHD)

Hide 45220 3.DISCONNECT STEERING INTERMEDIATE SHAFT ASSEMBLY

a.
C406787

Pull the steering intermediate shaft assembly (2) in the direction of the arrow until the clamping bolt (1) is accessible with the tool (reversible ratchet and extension).


b.

Loosen the E10 bolt (1).


c.

Pull the steering intermediate shaft assembly (2) off the steering column assembly in the direction of the arrow.


Hide 45025D 4.REMOVE NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY

a.
C413501

Unfasten nut (1).


b.

Pull off the No. 1 steering column hole cover sub-assembly (2) via the steering column assembly.