Home › Steering › STEERING COLUMN › STEERING INTERMEDIATE SHAFT
RM3650E _55 Steering _080257 STEERING COLUMN _0389221 STEERING INTERMEDIATE SHAFT A

STEERING COLUMN  STEERING INTERMEDIATE SHAFT  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

Damage to spiral cable sub-assembly.

The spiral cable sub-assembly can be damaged by twisting the steering wheel if the universal joint is disconnected from the steering gear or the steering shaft below or when the steering shaft is disconnected from the steering column below.

-

Secure steering wheel from twisting.




HINT:
·

Use the same procedure for LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.



PROCEDURE

Hide 12611 1.REMOVE NO. 1 ENGINE COVER (for RHD)

Hide 2.REMOVE FRONT WHEEL LH (for LHD)

Hide 3.REMOVE FRONT WHEEL RH (for RHD)

Hide 51219 4.REMOVE FRONT SUSPENSION MEMBER LOWER PROTECTOR

Hide 45220 5.REMOVE STEERING INTERMEDIATE SHAFT ASSEMBLY

a.
C406786

Loosen E10 bolt (1).


b.

Detach the steering intermediate shaft assembly (2) from the steering gear assembly in the direction of the arrow.


c.
C406787

Pull the steering intermediate shaft assembly (2) in the direction of arrow until the clamping bolt (1) can be accessed with the tool (reversible ratchet with extension).


d.

Loosen the E10 bolt (1).


e.

Pull the steering intermediate shaft assembly (2) off the steering column assembly in the direction of the arrow.


f.

Remove the steering intermediate shaft assembly (2) toward the bottom.