Hot fluids.
Risk of scalding!
Conduct all work in the vehicle wearing appropriate personal protective equipment only.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
17111
1.REMOVE INTAKE MANIFOLD
2. DRAIN ENGINE COOLANT (for High Temperature)
16671
3.REMOVE WATER VALVE
Hot fluids.
Risk of scalding!
Conduct all work in the vehicle wearing appropriate personal protective equipment only.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Unlock and pull off the No. 2 radiator hose, No. 1 water by-pass hose and water heater hose (1).
Detach the cable clips (1) from the water valve and the full-flow oil filter.
Unlock and disconnect plug connections (2).
Loosen E10 bolt (1).
Loosen E10 bolts (1).
Thread out the water valve (2) to the rear and out of the water inlet with water pump housing sub-assembly and remove.