Home › Engine / Hybrid System › B58 (INTAKE / EXHAUST) › INTAKE MANIFOLD
RM3650E _51 Engine / Hybrid System _080024 B58 INTAKE / EXHAUST _0388137 INTAKE MANIFOLD A

B58 INTAKE / EXHAUST  INTAKE MANIFOLD  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Working on 12 V vehicle electrical system.

Risk of short circuits! Risk of fire!

-

Detach battery earth lead from battery.




PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 51219 2.REMOVE FRONT SUSPENSION MEMBER LOWER PROTECTOR

Hide 17880 3.REMOVE AIR CLEANER HOSE ASSEMBLY

Hide 4.DRAIN ENGINE COOLANT (for Low Temperature)

Hide 17882 5.REMOVE NO. 2 AIR CLEANER HOSE

Hide 85010 6.REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY

Hide 55788A 7.REMOVE COWL TOP VENTILATOR LOUVER PROTECTOR

Hide 23285A 9.REMOVE NO. 1 CHECK VALVE

Hide 11.REMOVE ENGINE ROOM ECU BOX

a.
A442173

Unlock and loosen locks (1) and (2).


b.

Release the wiring harnesses from the engine room ECU box and set it aside.


c.
A442174

Loosen bolts (1).


d.

Guide out and remove the engine room ECU box (2).


Hide 17111 12.REMOVE INTAKE MANIFOLD

CAUTION:
·

Hot fluids.

Risk of scalding!

-

Conduct all work in the vehicle wearing appropriate personal protective equipment only.




a.
A441920

Unlock the locks (1) and set the wiring harness aside.


b.

Release wiring harness from holder (2) and lay to one side.


c.
C411720

Disconnect the wiring harness (1) from the cylinder head cover sub-assembly and set aside.


d.

Unlock and disconnect the connector (2) from the vacuum sensor.


e.

Disconnect the fuel tank breather tubes from the intake manifold where marked (3) and put to one side.


f.
C411721

Loosen the E10 bolt (1).


g.

Remove holder (2) from the throttle body with motor assembly and slide to the side.


h.

Unlock plug connection (3) and disconnect.


i.

Detach the clip in the marked area (4).


j.
A441923

Unlock and pull off the fuel suction tube sub-assembly (8).


k.

Loosen the bolts in the order (7) to (1).


l.
A441922

Loosen the E10 bolts (1).


m.

Unlock the locks (2) of the coolant lines under the intake manifold and disconnect the water by-pass hoses.

HINT:
·

Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.

·

Slightly raise air intake header.




n.

Remove intake manifold.


o.
A441750

Remove clip (1).


p.

Loosen the T25 bolt (2).


q.

Remove the vacuum sensor (3).


r.

Loosen the T20 bolt (4).


s.

Remove the No. 3 fuel vapor feed hose (5).


t.

Loosen the bolts (6).


u.

Remove the throttle body with motor assembly (7).