Home › Engine / Hybrid System › B58 (COOLING) › HEAT MANAGEMENT MODULE
RM3650E _51 Engine / Hybrid System _080128 B58 COOLING _0389433 HEAT MANAGEMENT MODULE A

B58 COOLING  HEAT MANAGEMENT MODULE  INSTALLATION  


PROCEDURE

Hide 16671 1.INSTALL WATER VALVE

a.
A441886

Replace the O-rings (1).


b.

Replace the O-rings (2).


c.

Coat O-rings (2) with coolant before installing.


d.
A441326

Clean sealing surfaces (1).

NOTICE:
·

Damage to the surface.

The use of metal-cutting tools (e.g. emery cloth) to clean the surfaces can damage them and lead to leaks or engine damage.

-

Do not use any metal-cutting tools.





e.
A441884

Insert water valve (2) into the water inlet with water pump housing sub-assembly from the rear.


f.

Position the water valve (2) and tighten the E10 bolts (1).

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)


g.
A441885

Tighten the E10 bolts (1).

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)


h.
A441883

Connect and lock the connector (2).

i.

The locks must engage audibly.



i.

Fasten the cable clip (1) on the water valve and on the full-flow oil filter.


j.
A441882

Connect the No. 2 radiator hose, No. 1 water by-pass hose and water heater hose (1) on the water valve and lock.

HINT:

Make sure that the connections are locked correctly. The locks must engage audibly.



Hide 3.ADD ENGINE COOLANT (for High Temperature)

Hide 4.INSPECT FOR COOLANT LEAK (for High Temperature)