16470
1.INSTALL RADIATOR RESERVE TANK ASSEMBLY
Make sure that the connections are locked correctly. The locks must engage audibly.
Guide the radiator reserve tank assembly (2) into the guide.
The lock (1) must audibly engage.
Guide the radiator reserve tank sub-assembly (3) with the journal (2) into the rubber mount and install.
The rubber mount must engage audibly.
Make sure that the lock (1) engages correctly.
Connect the connector (2) to the radiator reserve tank assembly (3) and lock.
The connector (2) must engage audibly.
Engage the clamp (4) to connect the wire harness to the radiator reserve tank assembly (3).
Connect and lock the heater water hose (1).
The heater water hose (1) must audibly engage.
Remove the disconnection tool from the heater water hose (1) and guide it out.
Connect and lock the radiator reserve tank hose (1).
The radiator reserve tank hose (1) must audibly engage.
Engage the clamp (2) to connect the No. 5 water by-pass hose to the radiator reserve tank assembly (3).
Remove the disconnection tool from the radiator reserve tank hose (1) and guide it out.
Top up the coolant to the maximum mark.
Close the reserve tank cap sub-assembly until the arrows are flush.
2.ADD ENGINE COOLANT (for High Temperature)
Materials harmful to health.
Contact with fluids harmful to health!
Note and follow safety information on containers.
Conduct all work in appropriate personal protective equipment only.
Life-long fill of coolant!
Do not reuse used coolant.
When replacing and removing components which rely on the corrosion protection effect of the coolant, it is essential to change the coolant. The cooling system must therefore be emptied and refilled.
In the case of other removal work involving the draining of part quantities of coolant, the coolant level must be topped up with new coolant.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Follow notes for repair work on the cooling system.
For additional information.
Click hereEngine / Hybrid System>B48 (COOLING)>COOLING SYSTEM>ON-VEHICLE INSPECTION
Loosen reserve tank cap sub-assembly (1).
Check the coolant level in the radiator reserve tank for the high-temperature coolant circuit and top up the coolant where required.
9.9 liters (10.5 US qts, 8.7 Imp. qts)
Expendable materials : Antifreeze and Corrosion Inhibitor Frostox HT-12
When using Antifreeze and Corrosion Inhibitor Frostox HT-12, dilute the Antifreeze and Corrosion Inhibitor Frostox HT-12 to 50% before using it.
Close reserve tank cap sub-assembly (1).
The arrows must be aligned.
51219
3.INSTALL FRONT SUSPENSION MEMBER LOWER PROTECTOR