16482
1.INSTALL LOW TEMPERATURE RADIATOR RESERVE TANK SUB-ASSEMBLY
Make sure that the connections are locked correctly. The locks must engage audibly.
Connect the No. 6 water by-pass hose (2) to the radiator reserve tank sub-assembly (1) and lock.
The No. 6 water by-pass hose (2) must audibly engage.
Guide in and install the radiator reserve tank sub-assembly (3).
The journal (2) must engage audibly in the rubber mount.
Make sure that the lock (1) engages correctly.
Connect and lock the No. 5 water by-pass hose (1).
The No. 5 water by-pass hose (1) must audibly engage.
Guide out and remove the disconnection tool.
Connect the connector (2) to the radiator reserve tank assembly (3) and lock.
Top up the coolant to the maximum mark.
Close radiator reserve tank cap sub-assembly.
2.ADD ENGINE COOLANT (for Low Temperature)
Materials harmful to health.
Contact with fluids harmful to health!
Note and follow safety information on containers.
Conduct all work in appropriate personal protective equipment only.
Life-long fill of coolant!
Do not reuse used coolant.
When replacing and removing components which rely on the corrosion protection effect of the coolant, it is essential to change the coolant. The cooling system must therefore be emptied and refilled.
In the case of other removal work involving the draining of part quantities of coolant, the coolant level must be topped up with new coolant.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Follow notes for repair work on the cooling system.
For additional information.
Click hereEngine / Hybrid System>B48 (COOLING)>COOLING SYSTEM>ON-VEHICLE INSPECTION
Loosen radiator reserve tank cap sub-assembly.
Check the coolant level in the radiator reserve tank sub-assembly for the low-temperature coolant circuit and top up the coolant, if necessary.
4.0 liters (4.2 US qts, 3.5 Imp. qts)
Expendable materials : Antifreeze and Corrosion Inhibitor Frostox HT-12
When using Antifreeze and Corrosion Inhibitor Frostox HT-12, dilute the Antifreeze and Corrosion Inhibitor Frostox HT-12 to 50% before using it.
Close radiator reserve tank cap sub-assembly.
The arrows must be aligned.
51219
3.INSTALL FRONT SUSPENSION MEMBER LOWER PROTECTOR