Vehicle falling down from a vehicle lift.
Danger to life!
Observe Owner's Handbook for vehicle hoist.
Do not exceed the approved load-carrying capacity and weight distribution of the vehicle lift.
Depending on the load situation of the vehicle: Perform weight compensation, particularly during removal of heavy components, e.g. engine.
Make sure the vehicle lift complies with the relevant statutory or country-specific accident prevention regulations and is serviced according to the regulations.
Observe the instructions of the repair instructions when positioning the swivel arms.
Motor vehicle may slip off the vehicle hoist where components are supported.
Danger! Life-threatening injuries!
Secure the vehicle hoist against lowering and lifting.
Motor vehicle may slip off the vehicle hoist if the weight is distributed unevenly.
Danger! Life-threatening injuries!
Ensure there is a specific weight compensation on the motor vehicle.
Perform wheel alignment after installation.
51206A
1.REMOVE REAR SUSPENSION MEMBER SUB-ASSEMBLY
77254
2.REMOVE NO. 1 FUEL EMISSION TUBE
Schematic diagram is for example purposes. Some parts may differ in certain details.
Unlock and disconnect snap fastener (1).
Unclip rear purge air line (2) from the holders (3).
Unlock and disconnect snap fastener (1).
Feed out and remove No. 1 fuel emission tube (2) from the holder (3).