Home › Engine / Hybrid System › B58 (EMISSION CONTROL) › FUEL EMISSION TUBE (for Rear)
RM3650E _51 Engine / Hybrid System _080101 B58 EMISSION CONTROL _0394172 FUEL EMISSION TUBE(for Rear) A

B58 EMISSION CONTROL  FUEL EMISSION TUBE(for Rear)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Vehicle falling down from a vehicle lift.

Danger to life!

-

Observe Owner's Handbook for vehicle hoist.

-

Do not exceed the approved load-carrying capacity and weight distribution of the vehicle lift.

-

Depending on the load situation of the vehicle: Perform weight compensation, particularly during removal of heavy components, e.g. engine.

-

Make sure the vehicle lift complies with the relevant statutory or country-specific accident prevention regulations and is serviced according to the regulations.

-

Observe the instructions of the repair instructions when positioning the swivel arms.


·

Motor vehicle may slip off the vehicle hoist where components are supported.

Danger! Life-threatening injuries!

-

Secure the vehicle hoist against lowering and lifting.


·

Motor vehicle may slip off the vehicle hoist if the weight is distributed unevenly.

Danger! Life-threatening injuries!

-

Ensure there is a specific weight compensation on the motor vehicle.




HINT:

Perform wheel alignment after installation.


PROCEDURE

Hide 51206A 1.REMOVE REAR SUSPENSION MEMBER SUB-ASSEMBLY

Hide 77254 2.REMOVE NO. 1 FUEL EMISSION TUBE (for Type A)

NOTICE:

Schematic diagram is for example purposes. Some parts may differ in certain details.


a.
A446790

Unlock and disconnect snap fastener (1).


b.

Unclip rear purge air line (2) from the holders (3).


c.
A446791

Unlock and disconnect snap fastener (1).


d.

Feed out and remove No. 2 fuel emission tube (2) from the holder (3).


Hide 77254 3.REMOVE NO. 1 FUEL EMISSION TUBE (for Type B)

NOTICE:

Schematic diagram is for example purposes. Some parts may differ in certain details.


a.
A446790

Unlock and disconnect snap fastener (1).


b.

Unclip rear purge air line (2) from the holders (3).


c.
A442270

Unlock and disconnect the plug connection (1) (on the active carbon filter).


d.
A446791

Unlock and disconnect snap fastener (1).


e.

Feed out and remove No. 2 fuel emission tube (2) from the holder (3).