Home › Engine / Hybrid System › B58 (LUBRICATION) › OIL PAN
RM3650E _51 Engine / Hybrid System _080066 B58 LUBRICATION _0394473 OIL PAN A

B58 LUBRICATION  OIL PAN  INSTALLATION  


PROCEDURE

Hide 1.INSTALL ENGINE OIL LEVEL SENSOR

a.
A441472

Replace engine oil level sensor gasket (1).


b.
A444624

Install the engine oil level sensor (2).


c.

Temporarily tighten nuts (1).

Torque:
2.0 N*m (20 kgf*cm, 18 in.*lbf)


d.

Fully tighten nuts (1).

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


Hide 12101 2.INSTALL OIL PAN SUB-ASSEMBLY

NOTICE:
·

Contaminant or foreign body.

Contamination can result in malfunctions, operating failure or leaks.

-

Adhere to the utmost cleanliness.

-

Protect components from contamination e.g. by covering.

-

Close off line connections with seal plugs.



·

Damage to the surface.

The use of metal-cutting tools (e.g. emery cloth) to clean the surfaces can damage them and lead to leaks or engine damage.

-

Do not use any metal-cutting tools.




a.
A444611

Remove coarse seal packing remains on the sealing surface of the cylinder block (1) and the sealing surface on the oil pan sub-assembly.

NOTICE:

The sealing surfaces must be free from oils, grease and cleaning agents.



b.
A444612

Remove fine seal packing remains on the sealing surface of the oil pan sub-assembly (1) and the sealing surface on the cylinder block.

NOTICE:

The sealing surfaces must be free from oils, grease and cleaning agents.



c.

Load the sealer gun with the seal packing.

Seal Packing:

Loctite 5970 Flange Sealant



d.
A441243

Apply sealing bead (1) with the seal packing in the marked area along the inner edge.

Height of the Sealing Bead:

2.0 to 2.5 mm (0.0787 to 0.0984 in.)


NOTICE:

The maximum application time of the seal packing is 12 minutes.



e.

Completely encircle the oil return orifice (arrow) with the sealing compound.


f.
A441242

Insert oil pan sub-assembly (1) upwards and forwards and position.


g.
A441936

Tighten all the oil pan sub-assembly E10 bolts (marks) hand-tight, do not yet tighten fully.


h.
A441935

Tighten the E10 bolts (1).

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


i.

Tighten down E10 bolts (2).

Torque:
24 N*m (245 kgf*cm, 18 ft.*lbf)


j.
A441936

Tighten all E10 bolts (marks).

Torque:
24 N*m (245 kgf*cm, 18 ft.*lbf)


k.

Connect connector and lock.

HINT:

Make sure the connector engages audibly.



l.

Secure clamp.


Hide 28100 3.INSTALL STARTER ASSEMBLY

Hide 51201 4.INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY

Hide 6.INSPECT FOR ENGINE OIL LEAK