87050C
1.REMOVE NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (M9)
Overview of No. 1 air conditioning radiator damper servo sub-assembly:
Disconnect the connector (3).
Remove T20 screws (2).
Remove No. 1 air conditioning radiator damper servo sub-assembly (M9) (1).
87208F
2.REMOVE WATER PIPE SUB-ASSEMBLY
87107A
3.REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY
88501
4.REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
Remove T20 screw (1).
Disconnect the cable (2) from the guides (arrows) and place to one side.
Disengage the claws (1).
Remove T20 screws (2).
Remove T20 screws (1).
Remove the blower housing (2) slightly and disengage from the hooks (3).
Remove T20 screws (1).
Disengage the claw (1).
Disengage the claws (1).
Remove T20 screws (2).
Disengage the claws (1) and guide out the lower radiator case sub-assembly (2) and remove it.
Disengage the hooks (1).
Remove the upper radiator case sub-assembly from the air conditioning radiator assembly (2).
Remove the T20 screws (1).
Disengage the claw (2) to remove the upper radiator case cover (3).
Remove the No. 1 cooler evaporator sub-assembly (1) with the seal (2) from the upper radiator case sub-assembly.