88501
1.INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
Install the No. 1 cooler evaporator sub-assembly (1) in the upper radiator case sub-assembly correctly.
Make sure that the seal (2) is positioned correctly.
Engage claw (2) to install the upper radiator case cover (3).
Tighten T20 screws (1).
Engage hooks (1).
Install the upper radiator case sub-assembly to the air conditioning radiator assembly (2).
Correctly feed in lower radiator case sub-assembly (2) and engage at the claws (1).
Engage claws (1).
Tighten T20 screws (2).
Engage the claw (1).
Tighten the T20 screws (1).
Engage blower housing (2) onto the hooks (3) and position correctly.
Tighten the T20 screws (1).
Engage claws (1).
Tighten T20 screws (2).
Connect cable (2) at the guides (arrows).
Tighten T20 screw (1).
87107A
2.INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY
87208F
3.INSTALL WATER PIPE SUB-ASSEMBLY
87050C
4.INSTALL NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (M9)
Install the No. 1 air conditioning radiator damper servo sub-assembly (M9) (1).
Tighten T20 screws (2).
Connect the connector (3).