Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM
RM3650E _58 Vehicle Interior _079885 HEATING / AIR CONDITIONING _0394546 AIR CONDITIONING SYSTEM G

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

Observe the following conditions prior to the air condition performance test:

-

Connect the Diagnosis system. Check the fault memory (no faults in the fault memory).

Vehicle management / Troubleshooting / Fault memory

-

Attach a thermometer with separate display element to the head restraint. Lay display element outwards out of passenger compartment.

-

Perform the test in a suitable workshop area at an ambient temperature above 18°C (64°F).

-

Vehicle temperature should be approximately the same as the ambient temperature in the workshop.

-

Engine must be at operating temperature.

-

Drive mode "ECO" must not be switched on.




PROCEDURE

Hide 1.INSPECT AIR CONDITION PERFORMANCE

a.

Warm up the engine.

i.

Check the engine warm-up condition.

HINT:
·

Connect the diagnosis system to the vehicle and enter the following menus.

Vehicle information / Control unit list / DME / Call up control unit functions / Diagnostic request / Diagnostic request / 102 Coolant temperature






b.

Heat passenger compartment:

i.

"A/C switch" is not activated during the heating process.


ii.

Close front door glass sub-assembly and doors.


iii.

Set air recirculation function.


iv.

Select air distribution mode for footwell and defrosting.


v.

Maximum temperature setting.


vi.

Maximum blower speed.


vii.

Start engine.



c.

Cool down passenger compartment:

i.

Switch on compressor with pulley assembly with "A/C switch" at a vehicle interior temperature of 45°C (113°F) (measured at the head restraint).

HINT:
·

On vehicles with MAX-AC switch:

-

Activation of (MAX-AC) = (maximum cooling power)






d.

After 5 minutes, measure both ventilation temperatures with a thermometer at the same time (center, left and right fresh air grille). The measured temperature must be 16°C (61°F) or less. The difference between the right and left must not be greater than 2°C (36°F).


e.

If one or both temperature specifications is not reached drain off heating and air conditioning system. Measure the amount of refrigerant drawn off and compare with the nominal fill amount.


f.

Check whether refrigerant loss is present.

i.

If there is a permissible loss of refrigerant, fill the refrigerant circuit with the nominal fill amount.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT>REPLACEMENT


ii.

If there is an impermissible loss of refrigerant, check the refrigerant circuit for tightness. After rectifying the leak, fill the refrigerant circuit with the nominal fill amount.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT>REPLACEMENT