Home › Power Source / Network › B48 (BATTERY / CHARGING) › FRONT POWER DISTRIBUTION BOX
RM3650E _57 Power Source / Network _080072 B48 BATTERY / CHARGING _0395484 FRONT POWER DISTRIBUTION BOX A

B48 BATTERY / CHARGING  FRONT POWER DISTRIBUTION BOX  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT POWER DISTRIBUTION BOX

a.
A446520

Position front power distribution box to the positive battery cable.


b.

Connect connector (2) and close the lock (1).


c.

Connect connector and lock.


d.
A449950

Feed in front power distribution box (2) downward.


e.

Tighten the T45 bolts (1).

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


f.
A446517

Insert the No.5 floor wire and tighten the T50 bolt (1).

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


g.

Feed in generator wire, starter wiring assembly and No. 5 floor wire and tighten nuts (2).

Torque:
20.5 N*m (209 kgf*cm, 15 ft.*lbf)


h.
A446516

Position cover for the jump start point (1) and clip it with the latch mechanisms (2).


Hide 2.INSTALL SEALING FRAME

a.
A446513

Feed in sealing frame (2).


b.

Tighten the T25 screws (1).

Torque:
2.5 N*m (25 kgf*cm, 22 in.*lbf)


Hide 55788A 3.INSTALL COWL TOP VENTILATOR LOUVER PROTECTOR

Hide 53681 4.INSTALL UPPER FRONT SUSPENSION CENTER BRACE

Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL