STEERING ANGLE SENSOR (w/ VSC) > INSTALLATION |
| 1. INSTALL STEERING SENSOR |
![]() |
Install the steering sensor onto the spiral cable.
| 2. REMOVE PLACE FRONT WHEELS FACING STRAIGHT AHEAD |
| 3. INSTALL SPIRAL CABLE |
Set the turn signal switch in neutral position.
Install the spiral cable sub-assembly with the 4 screws.
Connect the airbag connector and connector.
Install the steering column cover with the 3 screws.
| 4. CENTER SPIRAL CABLE |
Check that the ignition switch is OFF.
Check that the cable is disconnected from the negative battery terminal.
![]() |
Turn the cable counterclockwise by hand until it becomes harder to turn.
![]() |
Turn the cable clockwise about 2.5 turns to align the marks.
| 5. INSTALL STEERING COLUMN COVER UPPER |
Engage the claw, then install the upper steering column cover.
| 6. INSTALL STEERING COLUMN COVER LOWER |
Engage the 2 claws.
Install the lower steering column cover with the 2 screws.
| 7. INSTALL STEERING WHEEL ASSEMBLY |
Align the matchmarks on the steering wheel assembly and steering main shaft assembly.
Install the steering wheel assembly set nut.
| 8. INSTALL STEERING PAD ASSEMBLY |
![]() |
Support the steering pad with one hand, as shown in the illustration.
Connect the 2 airbag connectors.
Connect the horn ground harness to the steering pad.
![]() |
Confirm that the circumference groove of the "torx" screws fits in the screw case, and install the steering pad.
Using a "torx" socket wrench (T30), install the 2 screws.
| 9. INSTALL STEERING WHEEL COVER LOWER NO. 3 |
Engage the claw and install the No. 3 lower steering wheel cover onto the steering wheel assembly.
| 10. INSTALL STEERING WHEEL COVER LOWER NO. 2 |
Engage the claw and install the No. 2 lower steering wheel cover onto the steering wheel assembly.
| 11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 12. INSPECT STEERING PAD ASSEMBLY |
| 13. INSPECT SRS WARNING LIGHT |