Home › BRAKE › BRAKE CONTROL › STEERING ANGLE SENSOR (w/ VSC)

STEERING ANGLE SENSOR (w/ VSC) > REMOVAL

for Preparation Click here



1. PRECAUTION
(Click here)


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  1. Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.



3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


4. REMOVE STEERING WHEEL COVER LOWER NO. 2


F052155E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the steering wheel cover lower No. 2.



5. REMOVE STEERING WHEEL COVER LOWER NO. 3


F052156E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the No. 3 lower steering wheel cover.



6. REMOVE STEERING PAD ASSEMBLY
  1. Using a "torx" socket wrench (T30), loosen the 2 "torx" screws until the groove along the screw circumference fits in the screw case.



    H042354
  1. Pull the steering pad out of the steering wheel assembly and support the steering pad with one hand, as shown in the illustration.

    NOTICE:
    When removing the steering pad, take care not to pull the airbag wire harness.

  1. Disconnect the horn ground harness from the steering pad.

  1. Using a screwdriver, disconnect the airbag connectors.



    F045013E01
  1. Remove the steering pad.

    CAUTION:
    1. When placing the steering pad assembly, keep the upper surface of the steering pad facing upward.
    2. Never disassemble the steering pad.



7. REMOVE STEERING WHEEL ASSEMBLY


F044997E01
  1. Remove the steering wheel assembly set nut.

  1. Place matchmarks on the steering wheel assembly and main shaft assembly.

  1. Using SST, remove the steering wheel assembly.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)



8. REMOVE STEERING COLUMN COVER LOWER


F051318E01
  1. Remove the 2 screws.

  1. Disengage the 2 claws to remove the steering column cover lower.



9. REMOVE STEERING COLUMN COVER UPPER


F051319E01
  1. Disengage the claw, then remove the upper steering column cover.



10. REMOVE SPIRAL CABLE


F051337E01
  1. Disconnect the airbag connector and the connector from the spiral cable sub-assembly.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag with harness.

  1. Disengage the 3 claws and remove the spiral cable sub-assembly.



11. REMOVE STEERING SENSOR


F050586E01
  1. Release 6 claw fittings and remove the steering sensor from the spiral cable.