SFI SYSTEM > MIL Circuit |

| 1.CHECK THAT MIL IS ILLUMINATED |
Perform troubleshooting in accordance with the chart below.
| MIL Condition | Proceed To |
| MIL remains ON | A |
| MIL does not illuminate | B |
|
| ||||
| A | |
| 2.CHECK WHETHER MIL TURNS OFF |
Connect an intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester ON.
Check whether any DTCs have been stored (Click here). Note them down if necessary.
Clear DTCs (Click here).
Check if the MIL turns off.
|
| ||||
| NG | |
| 3.CHECK HARNESS AND CONNECTOR (CHECK FOR SHORT IN WIRE HARNESS) |
![]() |
Disconnect the ECM connector.
Turn the ignition switch to ON.
Check that the MIL is not illuminated.
Reconnect the ECM connector.
|
| ||||
| NG | ||
| ||
| 4.CHECK THAT MIL IS ILLUMINATED |
Check if the MIL is illuminated when the ignition switch is turned to ON.
|
| ||||
| NG | |
| 5.CHECK THAT ENGINE STARTS |
Turn the ignition switch to ON
Start the engine.
| Result | Proceed To |
| Engine starts | A |
| Engine does not start* | B |
|
| ||||
| A | |
| 6.INSPECT COMBINATION METER ASSEMBLY (MIL CIRCUIT) |
See the combination meter troubleshooting procedure (Click here).
|
| ||||
| OK | ||
| ||