Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SPIRAL CABLE

SPIRAL CABLE > INSTALLATION

for Preparation Click here



1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
  1. Check that the front wheels are facing straight ahead.



2. INSTALL SPIRAL CABLE SUB-ASSEMBLY
  1. Set the turn signal switch in neutral position.

    NOTICE:
    Make sure of the neutral position since the pin of the turn signal switch may be snapped.

  1. Install the spiral cable sub-assembly with the 4 screws.

    NOTICE:
    When replacing the spiral cable sub-assembly with a new one, remove the lock pin before installing the handle.

  1. Connect the airbag connector and connector.

  1. Install the steering column cover with the 3 screws.



3. CENTER SPIRAL CABLE
  1. Check that the ignition switch is OFF.

  1. Check that the cable is disconnected from the negative battery terminal.

    NOTICE:
    Do not start the operation for 90 seconds after disconnecting the cable from the negative battery terminal.



    F051312
  1. Turn the cable counterclockwise by hand until it becomes harder to turn.



    F051313E01
  1. Turn the cable clockwise about 2.5 turns to align the marks.

    HINT:
    The cable will rotate about 2.5 turns both left and right from the center.



4. INSTALL UPPER STEERING COLUMN COVER
  1. Engage the claw, then install the upper steering column cover.



5. INSTALL LOWER STEERING COLUMN COVER
  1. Engage the 2 claws.

  1. Install the lower steering column cover with the 2 screws.



6. INSTALL STEERING WHEEL ASSEMBLY
  1. Align the matchmarks on the steering wheel assembly and steering main shaft assembly.

  1. Install the steering wheel assembly set nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }



7. INSTALL STEERING PAD


H042362

NOTICE:
  1. Never use airbag parts from a different vehicle. When replacing parts, replace them with new ones.
  2. Make sure the wheel pad is installed to the specified torque.
  3. If the wheel pad has been dropped, or there are cracks, dents or other defects in the case or connector, replace the wheel pad with a new one.
  4. When installing the wheel pad, take care that the wiring does not interfere with other parts and is not pinched between other parts.

  1. Support the steering pad with one hand, as shown in the illustration.

  1. Connect the 2 airbag connectors.

  1. Connect the horn ground harness to the steering pad.



    F051342
  1. Confirm that the circumference groove of the "torx" screws fits in the screw case, and install the steering pad.

  1. Using a "torx" socket wrench (T30), install the 2 screws.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }



8. INSTALL NO.3 LOWER STEERING WHEEL COVER
  1. Engage the claw and install the No. 3 lower steering wheel cover onto the steering wheel assembly.



9. INSTALL NO.2 LOWER STEERING WHEEL COVER
  1. Engage the claw and install the No. 2 lower steering wheel cover onto the steering wheel assembly.



10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }



11. INSPECT HORN BUTTON ASSEMBLY


12. INSPECT SRS WARNING LIGHT
(Click here)