SIDE AIRBAG SENSOR > INSTALLATION |
| 1. REMOVE SIDE AIRBAG SENSOR |
Check that the ignition switch is OFF.
Check that the cable is disconnected from the battery negative (-) terminal.
Install the side airbag sensor with the bolt.
Check that there is no slack in the installation parts of the side airbag sensor.
Connect the connector to the side airbag sensor.
| 2. INSTALL CENTER PILLAR LOWER GARNISH LH |
![]() |
Engage the 2 claws and 2 clips, and install the center pillar lower garnish.
![]() |
Install the floor anchor of the front seat outer belt with the bolt.
| 3. INSTALL LAP BELT OUTER ANCHOR COVER |
![]() |
Engage the 3 claws and install the lap belt outer anchor cover.
| 4. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH |
![]() |
Install the rear door opening trim weatherstrip.
| 5. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH |
![]() |
Install the front door opening trim weatherstrip.
| 6. INSTALL REAR DOOR SCUFF PLATE LH |
![]() |
Engage the 8 claws and install the rear door scuff plate.
| 7. INSTALL FRONT DOOR SCUFF PLATE LH |
![]() |
Engage the 9 claws and install the front door scuff plate.
| 8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 9. INSPECT SRS WARNING LIGHT |