Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SIDE AIRBAG SENSOR

SIDE AIRBAG SENSOR > REMOVAL

for Preparation Click here


HINT:
Use the same procedures for the RH side and LH side.



1. PRECAUTION
(Click here)


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.


3. REMOVE FRONT DOOR SCUFF PLATE LH


    B087411E01
  1. Disengage the 9 claws and remove the front door scuff plate.



4. REMOVE REAR DOOR SCUFF PLATE LH


    B087412E01
  1. Disengage the 8 claws and remove the rear door scuff plate.



5. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH


    B087413E01
  1. Remove the front door opening trim weatherstrip.



6. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH


    B087414E01
  1. Remove the rear door opening trim weatherstrip.



7. REMOVE LAP BELT OUTER ANCHOR COVER


B087415E01

HINT:
Follow the same procedures as for the opposite side.

  1. Disengage the 3 claws and remove the lap belt outer anchor cover.



8. REMOVE CENTER PILLAR LOWER GARNISH LH


    B087416E01
  1. Remove the bolt and floor anchor of the front seat outer belt.



    B087417E01
  1. Disengage the 2 claws and 2 clips, and remove the center pillar lower garnish.



9. REMOVE SIDE AIRBAG SENSOR


F051303
  1. Remove the bolt and the side airbag sensor.

  1. Disconnect the connector from the side airbag sensor.