Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › REAR AIRBAG SENSOR

REAR AIRBAG SENSOR > REMOVAL

for Preparation Click here


HINT:
Use the same procedures for RH side and LH side.



1. PRECAUTION
(Click here)


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.


3. REMOVE REAR SEAT BACK HINGE COVER


    B087194E02
  1. for LH Side:

    HINT:
    Follow the same procedures as for the opposite side.


    1. Using a screwdriver with its tip taped in protective tape, disengage the 3 claws and remove the rear seat back hinge cover.

  1. for RH Side:

    1. Remove the rear seat back hinge cover .



4. REMOVE REAR SEAT BACK ASSEMBLY LH


    B087195E01
  1. Remove the 2 bolts and rear seat back.



5. REMOVE REAR SEAT BACK HINGE SUB-ASSEMBLY LH


    B087196E01
  1. Remove the 2 bolts and rear seat back hinge.



6. REMOVE REAR DOOR SCUFF PLATE LH


    B087412E01
  1. Disengage the 8 claws and remove the rear door scuff plate.



7. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH


    B087315E01
  1. Separate the rear door opening trim weatherstrip to the extent which allows the removal of the quarter trim lower panel and quarter inside trim board.



8. REMOVE LUGGAGE COMPARTMENT SIDE TRAY


    B087579E01
  1. Remove the 3 bolts.

  1. Disengage the 8 claws and 3 clips, and remove the luggage compartment side tray.



9. REMOVE QUARTER TRIM LOWER PANEL LH


    B087419E01
  1. Disengage the 2 claws and 2 clips, and remove the quarter trim lower panel.



10. REMOVE QUARTER INSIDE TRIM BOARD LH


    B087324E01
  1. Remove the bolt and remove the floor anchor of the rear seat outer belt.



    B087420E02
  1. Using a screwdriver with its tip taped in protective tape, disengage the claw and open the cover.



    B087421E01
  1. Remove the 3 screws.

  1. Disengage the 2 clips and remove the quarter inside trim board.



11. REMOVE REAR SEAT OUTER BELT ASSEMBLY LH


    B087316E01
  1. Remove the bolt and shoulder anchor.



    B087501E01
  1. Remove the 2 bolts and retractor.



12. REMOVE REAR AIRBAG SENSOR


F051311
  1. Disconnect the connector from the rear airbag sensor.

  1. Remove the nut and the rear airbag sensor.