WATER PUMP > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (for Pre Runner and 4WD Type) |
Remove the 4 bolts, then remove the engine under cover.
| 3. DRAIN ENGINE COOLANT |
![]() |
Remove the service hole cover from the engine under cover.
Install a vinyl hose onto the drain on the radiator side.
Fix the vinyl hose with tape.
![]() |
Loosen the 3 drain plugs on the engine and radiator, and drain the coolant.
Remove the radiator cap.
Drain the coolant from the reservoir tank.
Tighten the 3 drain plugs.
Remove the vinyl hose from the radiator.
| 4. REMOVE RADIATOR SUPPORT TO FRAME SEAL LH |
![]() |
Disengage the 9 clips, then remove the radiator support to frame seal.
| 5. REMOVE V-BANK COVER |
![]() |
Remove the 2 nuts, then remove the V-bank cover.
| 6. REMOVE FAN SHROUD |
![]() |
Disconnect the hose from the radiator reserve tank.
![]() |
Remove the 2 cooler hoses from the clamp (with automatic transmission).
Remove the 4 nuts from the fan pulley.
Remove the fan and generator V belt .
Remove the 2 bolts from the fan shroud.
Remove the fan pulley and fan shroud.
| 7. REMOVE AIR CLEANER ASSEMBLY |
![]() |
Disconnect the ventilation hose No. 2.
![]() |
Disconnect the vacuum hose.
Disconnect the mass air flow meter connector.
Remove the 2 wire harness clamps.
![]() |
Loosen the 2 hose clamps.
Remove the 2 bolts, then remove the air cleaner.
| 8. REMOVE WATER INLET |
![]() |
Disconnect the 2 oil cooler hoses (with oil cooler).
![]() |
Disconnect the 2 radiator hoses.
![]() |
Disconnect the 5 water by-pass hoses.
![]() |
Remove the 5 bolts and water inlet.
Remove the O-ring from the water outlet pipe.
Remove the gasket from the water pump.
| 9. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY |
![]() |
Remove the 2 bolts, then remove the 2 idler pulleys.
| 10. REMOVE GENERATOR ASSEMBLY |
![]() |
Disconnect the wire harness.
Remove the bolt and wire harness stay.
Disconnect the connector from the generator assembly.
Remove the terminal cap and nut.
Disconnect the wire harness from terminal B.
![]() |
Remove the 2 bolts, then separate the wire harness clamp bracket from the generator assembly.
![]() |
Remove the 2 bolts, then remove the generator assembly.
| 11. SEPARATE COOLER COMPRESSOR ASSEMBLY |
![]() |
Remove the bolt, then separate the suction hose sub-assembly.
![]() |
Disconnect the cooler compressor assembly connector.
Remove the 4 bolts, then separate the cooler compressor assembly from the V-ribbed belt tensioner assembly.
| 12. REMOVE V-RIBBED BELT TENSIONER ASSEMBLY |
| Drive Type | See Page |
| 2WD |
Click here
|
| Pre Runner and 4WD |
Click here
|
| 13. REMOVE WATER PUMP ASSEMBLY |
![]() |
Remove the 17 bolts, then remove the water pump and gasket.