Home › BRAKE › BRAKE CONTROL › BRAKE ACTUATOR (w/o VSC)

BRAKE ACTUATOR (w/o VSC) > INSTALLATION

for Preparation Click here



1. INSTALL BRAKE ACTUATOR BRACKET ASSEMBLY
  1. Install the bracket with the 2 nuts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



2. INSTALL BRAKE ACTUATOR


F050578E01
  1. Install the actuator with bracket with the 3 nuts.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }

    NOTICE:
    1. Be careful not to damage the brake tubes and wire harness.
    2. Tighten the bolts in order, from 1 to 3 as shown.



    F050577E01
  1. Using SST, connect each brake line to the correct position of the brake actuator, as shown in the illustration.

    SST
    09023-00101  

    Torque:
    15.2 N*m{ 155 kgf*cm , 11 ft.*lbf }

  1. Connect the brake actuator connector.

  1. Lock the connector lock lever.

    NOTICE:
    Make sure that the lever is locked securely.



3. INSTALL AIR INJECTION CONTROL DRIVER (for 2TR-FE)


F050574
  1. Install the air injection control driver with the 2 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Connect the 2 connectors.



4. FILL RESERVOIR WITH BRAKE FLUID


F050555

Fluid:
SAE J1703 or FMVSS NO. 116 DOT3



5. BLEED MASTER CYLINDER


F050556

HINT:
If the master cylinder has been disassembled or if the reservoir becomes empty, bleed the air from the master cylinder.

  1. Using SST, disconnect the brake lines from the master cylinder.

    SST
    09023-00101  

  1. Slowly depress the brake pedal and hold it there (step A).



    F050557
  1. Block the outer holes with your fingers, and release the brake pedal (step B).

  1. Repeat step A and B 3 or 4 times.



6. BLEED BRAKE LINE


F050558
  1. Connect the vinyl tube to the bleeder plug.

  1. Depress the brake pedal several times, then loosen the bleeder plug with the pedal held down (step C).

  1. At the point where the fluid stops coming out, tighten the bleeder plug, then release the brake pedal (step D).

  1. Repeat step C and D until all the air in the fluid has been bled out.

  1. Repeat the above procedure to bleed the air out of the brake line for each wheel.

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }



7. CHECK FLUID LEVEL IN RESERVOIR
  1. Check the fluid level and add fluid if necessary.

    Fluid:
    SAE J1703 or FMVSS NO. 116 DOT3



8. CHECK FOR BRAKE FLUID LEAKAGE


9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }

(Click here)


10. CHECK BRAKE ACTUATOR WITH INTELLIGENT TESTER
(Click here)