Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH

CRUISE CONTROL MAIN SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL CRUISE CONTROL MAIN SWITCH


    E076133E01
  1. Install the cruise control main switch with the 2 screws and connect the connector.



2. INSTALL STEERING PAD ASSEMBLY


H042362

NOTICE:
  1. Never use airbag parts from a different vehicle. When replacing parts, replace them with new ones.
  2. Make sure the wheel pad is installed to the specified torque.
  3. If the wheel pad has been dropped, or there are cracks, dents or other defects in the case or connector, replace the wheel pad with a new one.
  4. When installing the wheel pad, take care that the wiring does not interfere with other parts and is not pinched between other parts.

  1. Support the steering pad with one hand, as shown in the illustration.

  1. Connect the 2 airbag connectors.

  1. Connect the horn ground harness to the steering pad.



    F051342
  1. Confirm that the circumference groove of the "torx" screws fits in the screw case, and install the steering pad.

  1. Using a "torx" socket wrench (T30), install the 2 screws.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }



3. INSTALL LOWER NO. 3 STEERING WHEEL COVER
  1. Engage the 2 claws, install the No. 3 lower steering wheel cover to the steering wheel assembly.



4. INSTALL LOWER NO. 2 STEERING WHEEL COVER
  1. Engage the 2 claws, install the No. 2 lower steering wheel cover to the steering wheel assembly.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }



6. INSPECT STEERING PAD ASSEMBLY


7. INSPECT SRS WARNING LIGHT
(Click here)