Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


NOTICE:
  1. DTCs for the CAN communication system are as follows: U0073/94, U0100/65, U0123/62, U0124/95, U0126/63.
  1. Refer to troubleshooting of each system if DTCs regarding the CAN communication system are not output.



1.CHECK AND CLEAR DTCs

    NEXT


    2.CHECK CAN BUS LINE

      NEXT


      3.CHECK USING INTELLIGENT TESTER VIA CAN VIM
      1. Select "BUS CHECK" (Click here)

        Result: 
        A
        All ECUs and sensors connected to the CAN communication system are displayed.
        B
        All ECU or sensor not connected to the CAN communication system is displayed.
        C
        A few ECUs or sensors not connected to the CAN communication system are displayed.



      B.
      COMMUNICATION STOP MODE TABLE

      C.
      CHECK FOR AN OPEN IN ONE SIDE OF THE CAN BUS LINE
      A


      4.DTC COMBINATION TABLE
      1. Confirm trouble according to the combination of output DTCs regarding the CAN communication system.

      2. HINT:
        Previous CAN communication system DTCs may be the cause if CAN communication system DTCs are output and all ECUs and sensors connected to the CAN communication system are displayed on the intelligent tester's "BUS CHECK" screen via the CAN VIM.


      NEXT


      5.CIRCUIT INSPECTION

        NEXT


        6.IDENTIFICATION OF PROBLEM

          NEXT


          7.REPAIR OR REPLACE

            NEXT


            8.CONFIRMATION TEST

              NEXT

              END