Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



BUS CHECK

HINT:
The ECUs and sensors that are properly connected to the CAN communication system can be displayed using the intelligent tester via CAN VIM.



    G032145E01
  1. Select "BUS CHECK" from the "OBD/MOBD MENU" screen.



  2. G030152E01
  3. Press "ENTER" on the intelligent tester via CAN VIM.



  4. G032144E01
  5. The screen displays the ECUs and sensors that are properly connected to the CAN communication system.

    HINT:
    There is a communication stop in the system of any properly connected ECUs or sensors that are not displayed (Click here).


DTC TABLE BY ECU

HINT:
If CAN communication system DTCs are output, trouble cannot be determined only by the DTCs. Perform troubleshooting according to "HOW TO PROCEED WITH TROUBLESHOOTING" (Click here).

  1. Skid Control ECU

    HINT:
    DTC communication uses the SIL line.

    DTC No.2
    Detection Item
    U0073/94
    Control Module Communication Bus Off
    U0100/65
    Lost Communication With ECM/PCM "A"
    U0123/62
    Lost Communication With Yaw Rate Sensor Module
    U0124/95
    Lost Communication With Lateral Acceleration Sensor Module
    U0126/63
    Lost Communication With Steering Angle Sensor Module

  2. ECM

    HINT:
    The ECM is connected to the CAN communication system but CAN communication system DTCs are not output.