Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM

ANTI-LOCK BRAKE SYSTEM > DTC CHECK / CLEAR

for Preparation Click here



DTC CHECK / CLEAR (for Using a Intelligent Tester)


  1. Check DTCs.



      G035612E05
    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to the ON position.

    3. Turn the tester ON.

    4. Read the DTCs by following the prompts on the tester screen.



  2. Clear DTCs.



      G035612E05
    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to the ON position.

    3. Operate the intelligent tester to clear the DTCs.

      HINT:
      Refer to the intelligent tester operator's manual for further details.


DTC CHECK / CLEAR (for Using a SST Check Wire)


  1. Check DTCs.



      F100115E02
    1. Using SST, connect terminals TC and CG of the DLC3.

      SST
      09843-18040  

    2. Turn the ignition switch to the ON position.

    3. Read 2-digit DTCs by observing the blinking of the ABS warning light on the combination meter.

      HINT:
      1. If no code appears, inspect the ABS warning light circuit or TC and CG terminal circuit.
        Trouble Areas
        See Page
        ABS warning light circuit
        Click here
        Click here
        TC and CG terminal circuit
        Click here

      2. As an example, the blinking patterns of the normal system indication and DTCs 11 and 21 are shown below.


        C124739E01

      3. DTCs are explained in DTC chart (Click here).

    4. After completing the check, disconnect SST from terminals TC and CG of the DLC3, and turn the ignition switch to OFF.

      HINT:
      If 2 or more malfunctions are detected at the same time, the lowest numbered DTC is displayed first.



  2. Clear DTCs.



      F100115E02
    1. Using SST, connect terminals TC and CG of the DLC3.

    2. Turn the ignition switch to the ON position.

      SST
      09843-18040  



    3. BR03890
    4. Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.

    5. Check that the warning light blinks in the normal system indication pattern.

    6. Remove SST from the terminals of the DLC3.

    7. Turn the ignition switch to OFF.

      HINT:
      Clearing the DTCs cannot be performed by removing the battery cable.


END OF DTC CHECK / CLEAR
  1. Turn the ignition switch to the ON position.

  2. Check that the ABS warning light goes off within approximately 3 seconds.

  3. Turn the ignition switch to OFF.