Home › BODY › SEAT › FRONT SEAT ASSEMBLY (for Separate Seat Type Driver Side)

FRONT SEAT ASSEMBLY (for Separate Seat Type Driver Side) > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (w/ Front Seat Side Airbag) (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working (w/ Front Seat Side Airbag).


2. REMOVE SEAT TRACK COVER


B087374E01

HINT:
Follow the same procedures as for the opposite side.

  1. Disengage the 2 claws and remove the seat track cover.



3. REMOVE FRONT SEAT ASSEMBLY


    B087646E01
  1. Disconnect the 2 connectors.

  1. w/ Front Seat Side Airbag:

    1. Disconnect the connector.

  1. Using a clip remover, remove the wire harness clamp.



    B087375E01
  1. Remove the 4 bolts and front seat.