Home › RESTRAINTS › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY (for Regular Cab)

FRONT SEAT OUTER BELT ASSEMBLY (for Regular Cab) > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.


2. REMOVE FRONT DOOR SCUFF PLATE


    B087476E01
  1. Disengage the 8 claws and clip, and remove the front door scuff plate.



3. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP


    B087323E01
  1. Separate the front door opening trim weatherstrip to the extent which allows the removal of the quarter trim lower panel and quarter inside trim board.



4. REMOVE BACK PANEL TRIM COVER


    B087479E01
  1. for Separate Seat Type and Bench Seat Type:

    HINT:
    Follow the same procedures as for the opposite side (for Bench Seat Type).


    1. Disengage the 6 claws and remove the back panel trim cover.



    B087478E01
  1. for Bench Seat Type:

    1. Disengage the 6 claws and remove the back panel trim cover.



5. REMOVE BACK PANEL UPPER GARNISH


    B087480E01
  1. Disengage the 4 claws and 5 clips, and remove the back panel upper garnish.



6. REMOVE JACK ASSEMBLY (for Separate Seat Type)


7. REMOVE BACK PANEL TRIM COVER (for Separate Seat Type)


    B087481E01
  1. Remove the 2 clips.

  1. Disengage the 4 claws and remove the back panel trim cover.



8. REMOVE BACK PANEL TRIM (for Separate Seat Type)


    B087482E01
  1. Remove the 4 clips and back panel trim.



9. REMOVE QUARTER TRIM LOWER PANEL


    B087483E01
  1. Disengage the 2 claws and 3 clips, and remove the quarter trim lower panel.



10. REMOVE QUARTER INSIDE TRIM BOARD


    B087324E01
  1. for LH Side and Separate Seat Type RH side:

    1. Remove the bolt and the floor anchor of the front seat outer belt.



    B121774
  1. for Bench Seat Type RH Side:

    1. Remove the bolt and the floor anchor of the front seat outer belt.

    2. Disconnect the belt tension sensor connector.

    3. Remove the wiring harness clamp.



    B087484E02
  1. Using a screwdriver with its tip taped in protective tape, disengage the claw and open the cover.



    B087485E01
  1. Remove the 3 screws.

  1. Disengage the 2 clips and remove the quarter trim board.



11. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


    B087325E01
  1. Remove the bolt and shoulder anchor.



    B087326E01
  1. Disconnect the pretensioner connector as shown in the illustration.

  1. Remove the 2 bolts and retractor.



12. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    B087327E04
  1. Remove the bolt.

  1. Disengage the 2 claws and remove the front shoulder belt anchor adjuster.