Home › BODY ELECTRICAL › DOOR LOCK › KEY REMINDER WARNING SYSTEM

KEY REMINDER WARNING SYSTEM > Key Reminder Buzzer does not Sound

for Preparation Click here


DESCRIPTION

When the ignition switch is in the LOCK or ACC position, the key is in the ignition key cylinder and the driver side door is open, the key reminder buzzer sounds. The key reminder buzzer is activated when the multiplex network body ECU transmits a key switch signal and a driver side courtesy switch signal to the combination meter.

WIRING DIAGRAM


B125007E01


INSPECTION PROCEDURE

1.CHECK FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY (DRIVER SIDE)
  1. Move the room light switch to the DOOR position and open the driver side door. Then check that the room light turns ON.

    OK:
    Room light turns ON.



OK
Go to step 4
NG


2.INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY (DRIVER SIDE)


    B058556E14
  1. Remove the front door courtesy light switch assembly.

  1. Measure the resistance of the switch.

    Standard Resistance:
    Tester Connection
    Switch condition
    Specified Condition
    1 - Body ground
    Not pushed (ON)
    Below 1 Ω
    1 - Body ground
    Pushed (OFF)
    10 kΩ or higher

  1. Reinstall the front door courtesy light switch assembly.



NG
REPLACE FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY (DRIVER SIDE)
OK


3.CHECK WIRE HARNESS (FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY LH - BODY ECU)


    I044491E01
  1. Disconnect the D11 front door courtesy light switch assembly connector.

  1. Disconnect the 1F driver side J/B connector.

  1. Measure the resistance.

    Standard Resistance:
    Tester Connection
    Specified Condition
    (D11-1) - DTCY (1F-7)
    Below 1 Ω

  1. Reconnect the front door courtesy light switch assembly connector.

  1. Reconnect the driver side J/B connector.



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


4.CHECK BUZZER (COMBINATION METER)
  1. Check that the buzzer built into the combination meter sounds (Click here).



NG
REPLACE COMBINATION METER ASSEMBLY
OK


5.INSPECT UNLOCK WARNING SWITCH ASSEMBLY


    I044492E04
  1. Remove the U1 unlock warning switch assembly.

  1. Measure the resistance of the switch.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Not pushed
    10 Ω or higher
    1 - 2
    Pushed
    Below 1 Ω

  1. Reinstall the unlock of the switch assembly.



NG
REPLACE UNLOCK WARNING SWITCH ASSEMBLY
OK


6.CHECK WIRE HARNESS (SWITCH (DRIVER SIDE) - ECU AND BODY GROUND)


    I044490E01
  1. Disconnect the U1 unlock warning switch assembly connector.

  1. Disconnect the 1K driver side J/B connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard Resistance:
    Tester Connection
    Specified Condition
    (U1-1) - KSW (1K-10)
    Below 1 Ω
    (U1-2) - Body ground
    Below 1 Ω

  1. Reconnect the unlock warning switch assembly connector.

  1. Reconnect the driver side J/B connector.



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE DRIVER SIDE JUNCTION BLOCK (MULTIPLEX NETWORK BODY ECU)