Home › SUSPENSION & AXLE › SUSPENSION › FRONT LOWER SUSPENSION ARM (for 2WD)

FRONT LOWER SUSPENSION ARM (for 2WD) > INSTALLATION

for Preparation Click here



1. INSTALL FRONT SPRING BUMPER


F051499
  1. Install the front spring bumper.

    Torque:
    31 N*m{ 316 kgf*cm , 23 ft.*lbf }



2. TEMPORARILY TIGHTEN FRONT SUSPENSION LOWER ARM


F051498E01
  1. Align the matchmarks on the 2 camber adjust cams and temporarily tighten the 2 nuts.

  1. Install the front lower ball joint attachment LH, a new nut and a new cotter pin.

    Torque:
    140 N*m{ 1,428 kgf*cm , 103 ft.*lbf }



    F051497
  1. Install the front lower ball joint attachment LH with the 2 bolts.

    Torque:
    160 N*m{ 1,631 kgf*cm , 118 ft.*lbf }



3. TEMPORARILY TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING


F051496
  1. Install the front shock absorber with coil spring, bolt and washer, and temporarily tighten the nut.



4. INSTALL FRONT STABILIZER LINK ASSEMBLY


F051485E01
  1. Install the front stabilizer link LH with the 2 nuts, 2 cushions and 2 retainers.

    Torque:
    Nut A:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }
    Nut B:
    69 N*m{ 704 kgf*cm , 51 ft.*lbf }

    HINT:
    If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.



5. INSTALL FRONT WHEEL

Torque:
113 N*m{ 1,152 kgf*cm , 83 ft.*lbf }



6. STABILIZE SUSPENSION
  1. Jack down the vehicle.

  1. Bounce the vehicle up and down several times to stabilize the suspension.



7. FULLY TIGHTEN FRONT SUSPENSION LOWER ARM


F051498
  1. Fully tighten the 2 nuts.

    Torque:
    210 N*m{ 2,141 kgf*cm , 155 ft.*lbf }



8. FULLY TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING


F051496
  1. Fully tighten the nut.

    Torque:
    83 N*m{ 846 kgf*cm , 61 ft.*lbf }



9. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(Click here)