Home › TRANSMISSION ยท A750E AUTOMATIC TRANSMISSION › EXTENSION HOUSING REAR OIL SEAL

EXTENSION HOUSING REAR OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL AUTOMATIC TRANSMISSION EXTENSION HOUSING OIL SEAL


D028698E02
  1. Using SST and a hammer, carefully tap in a new oil seal until it is flush with the automatic transmission extension housing.

    SST
    09316-60011   (09316-00011, 09316-00051)

    Oil seal depth from flat end:
    5.4 to 5.8 mm (0.213 to 0.228 in.)

  1. Coat the oil seal lip with MP grease.



2. INSTALL PROPELLER WITH/CENTER BEARING SHAFT ASSEMBLY


C098709E02
  1. Align the matchmarks on the yoke and transfer flange.

  1. Install the propeller shaft with the 4 nuts and 4 washers.

    Torque:
    88 N*m{ 899 kgf*cm , 65 ft.*lbf }



    C098708E02
  1. Align the matchmarks on the yoke and differential flange.

  1. Install the propeller shaft with the 4 bolts, 4 nuts and 4 washers.

    Torque:
    88 N*m{ 899 kgf*cm , 65 ft.*lbf }



    D033899E01
  1. Provisionally install the center support bearing with 2 mounting bolts.

    HINT:
    Make sure the bearing is installed with the drain hole facing downwards.

  1. Torque the 2 bolts.

    Torque:
    36 N*m{ 369 kgf*cm , 27 ft.*lbf }



3. ADD AUTOMATIC TRANSMISSION FLUID
(Click here)