Home › BODY ELECTRICAL › AUDIO / VISUAL › STEERING PAD SWITCH

STEERING PAD SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL STEERING PAD SWITCH LH


E075998
  1. Install the steering pad switch cable onto the steering pad switch LH while holding the connector cover.



    E075997E01
  1. Hold the connector cover down to engage the 2claws as shown in the illustration.



    E075996
  1. Install the tab of the steering pad switch cable onto the steering pad switch LH as shown in the illustration.



    E075999E01
  1. Engage the 2 pins and install the steering pad switch LH.



    E062430E03
  1. Install the screw.

  1. Connect the connector.



2. INSTALL HORN BUTTON ASSEMBLY


H042362

NOTICE:
  1. Never use airbag parts from a different vehicle. When replacing parts, replace them with new ones.
  2. Make sure the wheel pad is installed to the specified torque.
  3. If the wheel pad has been dropped, or there are cracks, dents or other defects in the case or connector, replace the wheel pad with a new one.
  4. When installing the wheel pad, take care that the wiring does not interfere with other parts and is not pinched between other parts.

  1. Support the steering pad with one hand, as shown in the illustration.

  1. Connect the 2 airbag connectors.

  1. Connect the horn ground harness to the steering pad.



    F051342
  1. Confirm that the circumference groove of the "torx" screws fits in the screw case, and install the steering pad.

  1. Using a "torx" socket wrench (T30), install the 2 screws.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }



3. INSTALL NO. 3 LOWER STEERING WHEEL COVER
  1. Engage the claw and install the No. 3 lower steering wheel cover onto the steering wheel assembly.



4. INSTALL NO. 2 LOWER STEERING WHEEL COVER
  1. Engage the claw and install the No. 2 lower steering wheel cover onto the steering wheel assembly.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }



6. INSPECT HORN BUTTON ASSEMBLY
  1. Perform a diagnostic system check (Click here).



    H042163E01
  1. With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:

    1. Cuts, minute cracks or marked discoloration on the steering pad top surface or in the grooved portion.



7. INSPECT SRS WARNING LIGHT
(Click here)