DECELERATION SENSOR (for 4WD and Pre-Runner without VSC) > INSTALLATION |
| 1. INSTALL DECELERATION SENSOR |
![]() |
Install the deceleration sensor with the 2 bolts.
Connect the deceleration sensor connector.
| 2. INSTALL SENSOR BRACKET |
![]() |
Install the bracket with the bolt.
Install the wire harness clamp.
| 3. INSTALL COWL SIDE TRIM BOARD (for Regular Cab) |
![]() |
Engage the 2 clips and install the cowl side trim board.
Install the clip.
| 4. INSTALL COWL SIDE TRIM BOARD (for Access Cab) |
![]() |
Engage the 2 clips and install the cowl side trim board.
Install the clip.
| 5. INSTALL COWL SIDE TRIM BOARD (for Double Cab) |
![]() |
Engage the 2 clips and install the cowl side trim board.
Install the clip.
| 6. INSTALL FRONT DOOR SCUFF PLATE (for Regular Cab) |
![]() |
Engage the 8 claws and clip, and install the front door scuff plate.
| 7. INSTALL FRONT DOOR SCUFF PLATE (for Access Cab) |
![]() |
Engage the 9 claws and clip, and install the front door scuff plate.
| 8. INSTALL FRONT DOOR SCUFF PLATE (for Double Cab) |
![]() |
Engage the 9 claws and install the front door scuff plate.
| 9. INSTALL FRONT FLOOR FOOTREST |
![]() |
Engage the 2 clips and install the front floor footrest.
| 10. INSTALL FRONT SEAT ASSEMBLY (for Bench Seat Type) |
![]() |
Place the front seat in the cabin.
Slide the front seat to the most rearward position.
Tighten the 2 bolts on the front side.
Slide the front seat to the most forward position.
Tighten the 2 bolts on the rear side.
![]() |
Install the 2 wiring harness clamps.
Connect the 3 connectors.
![]() |
Install the belt of the front center seat outer belt into the front center seat outer belt guide.
| 11. INSTALL FRONT SEAT HEADREST ASSEMBLY (for Bench Seat Type) |
![]() |
Push in the 2 lock buttons of the 2 front seat headrest supports and install the 2 front seat headrests.
| 12. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH (for Bench Seat Type) |
![]() |
Slide the front seat to the most forward position.
Install the front seat inner belt with the bolt.
Install the 2 wiring harness clamps.
Connect the 2 connectors.
Engage the hook.
| 13. INSTALL FRONT SEAT INNER BELT ASSEMBLY RH (for Bench Seat Type) |
![]() |
Slide the front seat to the most forward position.
Install the front seat inner belt with the bolt.
Install the 2 wiring harness clamps.
Connect the connector.
Engage the hook.
| 14. INSTALL FRONT SEAT ASSEMBLY (for Separate Seat Type) |
![]() |
Place the front seat in the cabin.
Tighten the 2 bolts on the front side of the front seat.
Tighten the 2 bolts on the rear side of the front seat.
![]() |
Install the wire harness clamp.
Connect the 2 connectors.
w/ Front Seat Side Airbag:
Connect the connector.
| 15. INSTALL SEAT TRACK COVER (for Separate Seat Type) |
![]() |
Engage the 2 claws and install the seat track cover.
| 16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 17. CHECK ABS SENSOR SIGNAL |