BRAKE FLUID (w/ VSC) > BLEEDING |
| 1. FILL RESERVOIR WITH BRAKE FLUID |
| 2. BLEED BRAKE BOOSTER WITH ACCUMULATOR PUMP ASSEMBLY |
Turn the ignition switch to ON, and wait until the pump motor has stopped (step A).
Turn the ignition switch to OFF, and depress the brake pedal more than 20 times (step B).
Repeat step A and B 5 times (step C).
Turn the ignition switch to ON, and check that the pump stops after approximately 8 to 14 seconds.
| 3. BLEED BRAKE LINE |
Turn the ignition switch to ON, and wait until the pump motor has stopped.
![]() |
Front brake line.
Connect the vinyl tube to the brake caliper.
Depress the brake pedal several times, then loosen the bleeder plug with the pedal held down (step D).
At the point when the fluid stops coming out, tighten the bleeder plug, then release the brake pedal (step E).
Repeat step D and E until all the air in the fluid has been bled out.
Repeat the above procedures to bleed the other brake line.
![]() |
Rear brake line.
Connect the vinyl tube to the wheel cylinder.
Depress the brake pedal, hold it, and then loosen the bleeder plug.
Loosen the bleeder plug and release air.
When the air is completely bled out of the brake fluid through the bleeder plug, tighten the bleeder plug.
Repeat the above procedures to bleed the other brake line.
| 4. BLEED MASTER CYLINDER SOLENOID |
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Select "ACTIVE TEST" mode on the intelligent tester.
![]() |
Connect the vinyl tube to the rear wheel cylinder.
Loosen the bleeder plug.
Select "SRMF & SRMR" to drive the solenoids and bleed air from the rear wheel cylinder (step F).
Repeat step F until all the air in the brake fluid is bled out.
When the air is completely bled out of the brake fluid through the bleeder plug, tighten the bleeder plug.
Repeat the above procedures to bleed the other brake line.
Turn the ignition switch to OFF.
Turn the ignition switch to ON.
Clear DTC (Click here).
| 5. CHECK FLUID LEVEL IN RESERVOIR |
Turn the ignition switch to OFF, and depress the brake pedal more than 20 times (until the pedal reaction feels light and pedal stroke becomes longer), and adjust the fluid level to the MAX level.
When the ignition switch is turned to the ON, brake fluid is sent to the accumulator and the fluid level decreases by approximately 5 mm from the level when the ignition switch is off (normal).