VEHICLE STABILITY CONTROL SYSTEM > DTC CHECK / CLEAR |
| DTC CHECK/CLEAR (for Using a Intelligent Tester) |
Check DTCs.
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester ON.
Read the DTCs by following the prompts on the tester screen.
Clear DTCs.
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Operate the intelligent tester to clear the codes.
| DTC CHECK/CLEAR (for Using a SST Check Wire) |
Check DTCs.
Using SST, connect terminals TC and CG of the DLC3.
Turn the ignition switch to the ON position.
Read 2-digit DTCs by observing the blinking of the ABS warning light and the VSC TRAC warning light on the combination meter.
| Trouble Area | See page |
| ABS warning light circuit |
Click here
Click here |
| VSC TRAC warning light circuit |
Click here
Click here |
| TC and CG terminal circuit |
Click here
|

After completing the check, disconnect SST from terminals TC and CG of the DLC3, and turn the ignition switch to OFF.
If 2 or more malfunctions are detected at the same time, the lowest numbered DTC is displayed first.
Clear DTCs.
![]() |
Using SST, connect terminals TC and CG of the DLC3.
Turn the ignition switch to the ON position.
![]() |
Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.
Check that the warning light blinks in the normal system indication pattern.
Remove SST from the terminals of the DLC3.
Turn the ignition switch to OFF.
| END OF DTC CHECK/CLEAR |
Turn the ignition switch to the ON position
Check that the ABS warning light and VSC TRAC warning light go off within approximately 3 seconds.
Turn the ignition switch to OFF.