CLUTCH PEDAL > INSTALLATION |
| 1. INSTALL CLUTCH PEDAL NO.1 CUSHION |
Install the No. 1 cushion onto the clutch pedal.
| 2. INSTALL CLUTCH PEDAL SHAFT COLLAR |
![]() |
Apply MP grease to the clutch pedal shaft collar.
Install the clutch pedal shaft collar onto the clutch pedal.
| 3. INSTALL CLUTCH PEDAL BUSH |
![]() |
Apply MP grease to 2 new bushes.
Install the 2 bushes onto the clutch pedal.
| 4. INSTALL CLUTCH PEDAL PAD |
| 5. INSTALL CLUTCH PEDAL SPRING HOLDER |
![]() |
Apply MP grease to the contact surface of the clutch pedal spring holder.
Install the clutch pedal spring holder.
| 6. INSTALL CLUTCH PEDAL SUB-ASSEMBLY |
![]() |
Install the clutch pedal onto the clutch pedal support with the bolt and nut.
| 7. INSTALL TURN OVER SPRING SEAT COMPRESSION SPRING |
![]() |
Apply MP grease to the contact surfaces of the spring holder, clutch pedal and spring.
Install the spring onto the clutch pedal and spring holder.
| 8. INSTALL CLUTCH MASTER CYLINDER ASSEMBLY |
| 9. BLEED BRAKE LINE (w/o VSC) |
| 10. BLEED CLUTCH PIPE LINE |
| 11. INSPECT AND ADJUST CLUTCH PEDAL SUB-ASSEMBLY |
Lift the floor carpet.
![]() |
Check that the pedal height is correct.
Adjust the pedal height.
Loosen the lock nut and turn the stopper bolt until the height is correct. Tighten the lock nut.
Check that the pedal free play and push rod play are correct.
Depress the pedal until the clutch resistance begins to be felt.
Gently depress the pedal until the resistance begins to increase a little.
![]() |
Adjust the pedal free play and push rod play.
Loosen the lock nut and turn the push rod until the free play and push rod play are correct.
Tighten the lock nut.
After adjusting the pedal free play, check the pedal height.
Connect the air duct and install the lower finish panel.
![]() |
Check the clutch release point.
Pull the parking brake lever and use wheel chocks.
Start the engine and allow it to idle.
Without depressing the clutch pedal, slowly move the shift lever into the reverse position until the gears engage.
Gradually depress the clutch pedal and measure the stroke distance from the point that the gear noise stops (release point) up to the full stroke end position.
| 12. CHECK BRAKE FLUID LEAKAGE (w/o VSC) |
| 13. CHECK FOR CLUTCH FLUID LEAKAGE |
| 14. CHECK FLUID LEVEL IN RESERVOIR |