Home › ENGINE ยท 1GR-FE › STARTING › STARTER (for 4WD)

STARTER (for 4WD) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE NO.1 ENGINE UNDER COVER SUB-ASSEMBLY
  1. Remove the 4 bolts, then remove the engine under cover.



3. REMOVE NO.2 EXHAUST FRONT PIPE ASSEMBLY
(Click here)


4. REMOVE FRONT FENDER SEAL LH


A076411E01
  1. Remove the 5 clips, then remove the front fender splash shield rear LH.



5. REMOVE NO.2 STEERING INTERMEDIATE SHAFT


    A076412E01
  1. Loosen bolt A and remove bolt B, then separate the steering intermediate shaft No. 2



6. REMOVE STARTER ASSEMBLY


    G036168E01
  1. Disconnect the terminal 50 connector from the starter assembly.

  1. Remove the nut, then remove the wire harness from terminal 30.

  1. Remove the 2 bolts, then remove the starter assembly.