SEAT POSITION SENSOR (for Separate Seat Type) > INSTALLATION |
| 1. INSTALL SEAT POSITION SENSOR |
Check that the ignition switch is OFF.
Check that the cable is disconnected from the battery negative (-) terminal.
Using a "torx" socket wrench (T30), tighten the "torx" screw to install the seat position sensor.
Make sure that the clearance between the seat position sensor and the seat rail is within 0.6 mm (0.023 in.) and 2 mm (0.079 in.).
Check that there is no slack in the installation parts of the seat position sensor.
Connect the connector to the seat position sensor.
| 2. INSTALL FRONT SEAT ASSEMBLY |
![]() |
Place the front seat in the cabin.
Tighten the 2 bolts on the front side of the front seat.
Tighten the 2 bolts on the rear side of the front seat.
![]() |
Install the wire harness clamp.
Connect the 2 connectors.
w/ Front Seat Side Airbag:
Connect the connector.
| 3. INSTALL SEAT TRACK COVER |
![]() |
Engage the 2 claws and install the seat track cover.
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 5. INSPECT SRS WARNING LIGHT |